Product Description
- DIY Purpose
Raspberry Pi
Arduino DIY - Power Bank for Mobile Devices
- 5V Wide USB Discharge Port
- Specially Designed for Powering Raspberry Pi
- LED Indicators for Battery level
- Full Protection Circuit
- Charge and Discharge Synchronization
- 1S 26650 Lithium Battery Charging and Protection Board w 5V Boost Circuit- BCPB1 (PS-BC12114) X1
Details
1S 26650 Lithium Battery Charging and Protection Board w 5V Boost Circuit- BCPB1
Overview:
BCPB1 is a highly efficient and highly reliable lithium battery charging and protection board with 5V boost circuit integrated. It is designed for 1piece 26650 Lithium Battery and can be used as a power bank for Mobile Phones and Raspberry Pi. Its palm size makes it suitable for portable DIY applications. With 5V boost circuit employed, when using BCPB1 to power Mobile Phones, the 5V USB discharge port can provide maximum current as 2A. Raspberry Pi can be easily and conveniently installed on BCPB1 through the pre-mounted standoffs and be powered by the direct contact of pogp pin on the BCPB1 and POS4, 6 OF 40 pin connectors of Raspberry Pi, without any occupation of 40 GPIO pin headers. Battery Level Indicators are equipped for visualized display.
BCPB1 is equipped with full protection circuit, such as overcurrent, over-temperature, short circuit and over/under voltage protection, ensuring the reliablity.
Note: 1. Sure Electronics does not provide technical support for any behavior of connecting the battery charger and balance protection board with power supply out of the recommended range. Warranty will be lost due to this.
2. Turn off the apparatus if it is disused for long time.
3. For the 1st time to charge this new battery board/ make the board active, it is normal to take much longer time to make the board fully charged.
4. If your board goes into protection status or the battery has been re-installed, please recharge the board with power adapter to make it active again.
5. Please check the battery polarity before installation.
6. Please be noted that this board is forbidden to be connected in parallel or in series.
7. It is normal that charge LED blinks when the charge time exceeds the recommend total time.
Applications:
Key Features:
Electrical Specifications:
Connections:
Package Content:
Additional Information
Additional Information
UPC | No |
---|